Following instructions is one thing, but when instructions are not quite complete then obviously things can go wrong! Well it started last night when the allen key wouldn’t undo a bolt (that was on a prebuilt part). I was using metric and then i thought maybe its imperial, but no it was not the case, i had to undo the bolts with pliers because they have been rounded. This would have a lot easier if it didn’t have a sleeve washer on it. At the end of the day i ended up having to undo these bolts twice because the instructions are a little all over the place but have stopped tonight because after looking a little ahead on the instructions again I’ll have to undo them again, so with saying this progress is a little slower than expected. Here’s some pics of where I’m at.